ObsidianWire Custom HSH Wiring Harness for Strat

Product Description

Super Easy Install

All ObsidianWire Pro-Wired Electronics are super easy to install, and allow for solder-less pickup changes with ObsidianWire Plug, Play & Enjoy connectors.

HSH Strat® Wiring Harness

The ObsidianWire HSH Wiring Harness for Fender® Stratocaster®, is the perfect way to open up your humbuckers with some extra clarity and output, while retaining that sweet single coil tone.

The trouble with a traditional wiring kit in a Strat® with humbuckers and single coils is that humbuckers need a good 500k potentiometer for full clarity and output, while the single coils need a 250k set of tone and volume controls to tame some of their natural highs.

ObsidianWire is the perfect solution with a special custom design allowing for auto switching between 500k tone and volume controls in the full humbucker positions, and 250k controls for the single coil positions.

The ObsidianWire HSH Wiring Harness

– Auto switch between 500k & 250k tone and volume controls

– 500k For the Humbuckers (Full Output & Clarity)

– 250k for the Single Coil (Traditional Strat Tone)

– Auto Split Humbuckers in Positions 2 + 4 (Perfect Strat Quack)

Furthermore, when you move your switch into the mixed pickup positions the humbucker coils split (requires four conductor humbuckers), with one of them pairing up with the middle pickup for traditional Strat tone.

The Custom HSH Controls:

1: Bridge Humbucker in Full Mode (500k controls // Rear tone control)

2: Bridge Humbucker in Split mode* + Middle Pickup (250k Controls // Front tone control)

3: Middle Pickup (250k Controls // Front tone control)

4: Neck Humbucker in Split mode* + Middle Pickup (250k Controls // Front tone control)

5: Neck Pickup (500k controls // Rear tone control)

* Coil Splitting Requires Four Conductor Neck + Bridge Pickups

Crystal Clear Tone

To make your tone crystal clear at lower volumes we also include an ObsidianWire Custom Spec Treble Bleed Mod. This prevents tone ‘muddiness’ at low volumes by allowing high frequencies to pass along a separate path to your amp, rather than being stopped short by the increasing resistance at the volume control.

World’s Best Craftsmanship and Components

ObsidianWire Custom Select Pots (Crafted by CTS) (+/-10%) (Matched to +/-2%) SPLIT SHAFT

ObsidianWire / Schaller Propriety HSH Switch (Requires Metric Tip)

Genuine Switchcraft Output Jack

ObsidianWire Custom Select 150 Series Polyester Film Capacitors (Hand Tested to +/-10%)

ObsidianWire Premium Selected Volume Mod / Treble Bleed – Improved Volume Taper & Clarity

Easy to Follow Install Manual

Endless Customer Support

Installation Info

Compatibility

Note: If Converting to HSH // Humbucker body routes & Pickguard Required

American and Mexican series Fender® Strat® – Direct Fit // Right Hand Guitar Only

Japanese Fender & Squiers® – You will need to widen the control holes out to 10mm and get new US Spec, 24 spline knobs to fit the higher grade electronics. // Right Hand Guitar Only

Other Models – We cannot guarantee that these will fit any other guitar.

Left Hand Guitars – Does NOT Fit